Aerotech Ensemble LAB, Руководство по оборудованию

Страница: 58 / 68

Installation and Configuration Ensemble LAB Hardware Manual
2.7. Communication (Ethernet and USB)
Either USB or Ethernet can be used to connect any of the supplied software applications or a custom
application built with the supplied .NET library to the controller. Ethernet sockets are also available for
general ASCII communication with another hardware device. Refer to the Help file for more information
about the ASCII interface.
2.7.1. USB Interface
The USB connection is established through a Type B female connector labeled USB on the Ensemble LAB
(refer to
Figure 2-32 ). This can be accomplished by one of these two methods:
Method 1 : Directly connect to the PC with a standard USB cable. The cable connector type must be
Type A or Type B male depending on the PC, and Type B male on the Ensemble LAB.
Method 2 : Connect through a USB hub. The cable connector type must be Type A or Type B male
depending on the hub, and Type B male on the Ensemble LAB.
Method 1 is the most commonly used. Method 2 is necessary only when the number of Ensemble LABs to
be connected is larger than the number of available USB ports on the PC.
J103 J104
J105 J106
TB101
ETHERNET
USB ESTOP JOYSTICK AUX I/O
AXIS
4 3 2 1
WARNING: HAZARDOUS
VOLTAGE PRESENT UP TO
10 MINUTES AFTER
POWER IS DISCONNETED
J104
USB
Figure 2-32: USB Connection Location (for PC Communication)
58 Chapter 2 www.aerotech.com