TAB.10 PGD0
29.12.
A
134
Ø 4
34.5
dima di foratura
drilling template
127x69 mm
Ø 4
156
125
67
18
30
82
82
31
156
The
pGD0
graphical display is an electronic device that allow
complete management by the display of icons (defined at the
level of application software). The software is only resident in
the pCO. The terminal does not require any additional software
during use.
Panel assembly
These terminals have been designed for panel assembly, the
drilling template must have dimensions of 127x69 mm + 2
circular holes with diameter of 4 as indicated in fig. 9.
For installation follow the instructions given below:
Connect the telephone table
1.
Insert the terminal into the hole without the front frame
2.
and using the countersunk screws contained inside the
packaging, fix the device to the panel in the seats indicated
in fig. 7
(*the box is not supplied)
Finally, install the snap-action frame
3.
Wall-mounting
Wall-mounting of the terminal envisions the initial fixing of the
rear container A (Fig. 8), by means of a standard box with 3
modules for switches.
Fix the rear container to the box using the oval head screws
1.
present inside the packaging;
Connect the telephone cable;
2.
Place the front piece onto the rear container and fix
3.
everything using the countersunk screws present inside the
packaging as illustrated in Fig. 8;
Finally, install the snap-action frame.
4.
Electric connection
Connect the telephone cable (code S90CONN00*), coming from
the pCO board, to the relevant connector (RJ12) positioned on
the rear of the terminal.
Technical features
Display
Type:
FSTN graphics
Backlighting:
green LEDs (controlled from
“application software”)
Power supply
Voltage:
power supply from pCO by
telephone connector or external
18/30 Vdc source protected by
an external 250 mAT fuse
Maximum input power:
0.8 W
Maximum distances
pLAN network max. length: 500 m with paired shielded AWG22
cables
pCO terminal distance:
50 m with telephone cable (for
longer lengths contact the head
offices)
General
Protection rating: IP65 with panel assembly
IP40 with wall-mounting
Fig.9.
Fig.10.
Fig.11.
Fig.12.
Fig.13.
*
NOTE
For further information refer to the manual dedicated to the
accessory
50