TF7039GB_A_NOT
Page 43 of 48
8.3.2.
MULTI-CABLE FEEDTHROUGH
Under the connection cover, there is a multi-cable feedthrough for all necessary sen-
sor and signal lines to the switch box inside the unit.
Proceed as follows:
Pierce the membrane with a pointed object or cut the end with a side cutter to create
a
small hole
. Ensure that the hole is clearly smaller than the diameter of the cable
to be fed through.
Push the cable through the hole in the membrane.
Finally, pull the cable back by approx. 20 mm until the membrane is flush around the
cable and closes tightly.
8.3.3.
AIR FILTER
To service the air filter, open service panel B opposite the exhaust air connection.
The filter is located in the filter slot below the hood in the middle of the unit. To remove
the air filter from the unit, simply pull it out of the filter insert in the direction of the
opened service panel (picture on the right).
When inserting the filter, make sure that it does not jam in the
filter insert and that it is flush with the filter insert.
Filter type:
Eco+ 111
and
Eco+ 121:
Filter cell (filter class G4 / ISO Coarse 75%)
Aereco item no.: 310170
Filter type:
Eco+ 131:
Filter cell (filter class G4 / ISO Coarse 75%)
Aereco item no.: 310171
