TF7039GB_A_NOT
Page 22 of 48
All data for exhaust air at 20°C and 50% rel. humidity and for water. Data according to EN 14511:2013
5.
RECEIVING AND MOVING THE UNIT
The unit is shipped ex works wrapped in foil on a pallet. Pay attention to possible damage to the packaging
or the exhaust fan. Avoid striking or knocking it at all costs. Any transport damage must be reported to the
carrier immediately. Before moving the unit, the load capacity of the hoists used must be checked. The unit
may only be moved by qualified and suitably equipped personnel.
STORAGE
Store the device in a dry and weatherproof place until final assembly. Avoid exposure to extreme
heat or cold, or exposure to dusty ambient air. Condensate or rainwater under the packaging
cannot dry off and will cause corrosion damage to the unit surfaces.
INSTALLATION SITE AND FIXING
The unit is approved exclusively for outdoor installation on the flat roof of a building. For this purpose, pro-
fessional and sufficiently secure fastening or weighting is required in order to permanently withstand wind
and weather loads outdoors.
The unit may only be installed on buildings up to a maximum height of 60 m and only in wind
zones 1-3 (DIN EN 1991-1-4:2005).
Use only approved stainless-steel fasteners of sufficient number and size. The decisive factors here are the
conditions at the installation site, which are influenced by the wind zone there, the building height and the
terrain exposure.
The need for measures to be taken shall be assessed on a case-by-case basis, taking into account local
conditions. Dimensions and weights can be found in the technical data.
Before the unit is installed, where it is to be installed must be agreed with the decision-makers involved, and
the following points must be observed:
The supporting surface must be able to withstand the weight of the unit.
The safety distances between the units and other devices or building elements must be strictly
observed.
The device must be installed by a technician in accordance with the applicable national laws of
the country of use.
The technically required minimum clearances must be provided in order to allow work to be carried
out for regular and extraordinary maintenance.
It should be noted that the heat pump module can transmit vibrations during operation.
When securing the unit, check carefully that it is balanced.
The static proof for stability and the resulting type of fastening must be provided by the customer.
The specific local conditions, e.g. wind loads, must be taken into account.
