13
12
3. Once the inclusion is successful, the
green light on your Key Fob will stay
lit for 2 seconds and then blink again.
Otherwise, the red light on your Key
Fob will stay lit for 2 seconds before
the green light blinks again.
4. Repeat step 2 for any other devices
you wish to add to your network.
5. Once you’re finished, press any button
on your Key Fob to exit this mode.
Your Key Fob is capable of removing
devices from your Z-Wave network
when it is either your network’s primary
controller or your network permits your
Key Fob, as a secondary controller, to
permanently remove devices.
1. Press your Key Fob’s remove button.
Your Key Fob’s red light will pulse
slowly.
Removing devices from your
Z-Wave network.
2. Press the Z-Wave button on the device
that you wish to remove. If you’re unsure
of how to do this, refer to its user manual.
3. If the removal is successful, the green
light on your Key Fob will stay lit for 2
seconds and then its red light will blink.
Otherwise, the red light will stay lit for 2
seconds before again blinking.
4. Repeat step 2 for any other devices you
wish to remove from your network.
5. Once you’re finished, press any button
on your Key Fob to exit removal mode.
Your Key Fob has two use modes,
Scene Mode and Group Mode. When in
Scene Mode, your select which devices
your Key Fob can control by using your
primary controller, generally a gateway or
a hub.
If in Group Mode, you configure your Key
Fob to directly control devices as follows;
Selecting which devices to control.
