Monitoring Energy Consumption.
The Aeotec Nano Switch can report wattage energy usage or kWh energy usage to a ZWave control point when requested. If
this function is supported by the control points, the energy consumption will be displayed in the user interface of the control
points. (The specific ZWave commands supporting energy monitoring are the Meter Command Class. Automatic reports are
sent to association group 1, which is setup via the Association Command Class.) Please consult the operation manual for
these control points for specific instructions on monitoring the Nano Switch.
Note: The model ZW139 Nano Switch does not have the ability to monitor energy consumption. The model ZW116 Nano
Switch supports the energy metering feature and you can see the words “with Energy Metering” on its packaging box.
Security or Nonsecurity feature of your Nano Switch in ZWave
network.
Including Nano Switch as a nonsecure device:
If you want your Nano Switch as a nonsecure device in your ZWave network, press the Action Button once on Nano Switch
when you pair it to your gateway.
If inclusion is successful, the green LED will be on for 2 seconds, and then return to a solid indication. If inclusion is
unsuccessful, the red LED will be on for 2 seconds and then return to a colorful gradient.
Including Nano Switch as a secure device:
In order to take full advantage of the Nano Switch, you will want your Nano Switch as a security device that uses encrypted
messages to communicate in your Zwave network. A security enabled controller/gateway (or ZWave Plus controller) is
required.
1. Set your ZWave Plus controller into pairing mode.
2. Press the Action Button 2 times within 1 second on the Nano Switch, the blue LED (secure indication) will blink to
indicate the Nano Switch is entering into secure pairing mode.
3. If the Nano Switch has been successfully added to your ZWave network, its RGB LED will be solid. If the pairing was
unsuccessful, the red LED will be on for 2 seconds and then remain a colorful gradient, repeat the instructions above
from step 1.
Reset your Nano Switch.
