Intended Use
Operations Manual Thyro Power Manager
Page 10 of 52
Version 2008-03-11
3.4 Safety Instructions
3.4.1
Accident Prevention Regulations
Please unconditionally observe the accident prevention regulations of the host country as
deployed within, and the generally valid safety instructions in accordance with IEC 364.
The following 5 safety rules must be complied with, prior to the beginning of all work
performed to the Unit:
Attention Mains Voltage!
Safety rules for work performed to electrical facilities:
1. Disconnect equipment from the mains (establish a voltage free status)
2. Secure equipment against re-activation
3. Determine voltage free status of equipment by measurement
4. Earthen and short-circuit equipment
5. Cover or establish borders to neighboring parts under voltage
3.4.2
General Safety Notes
Important instructions stand out by the use of warning symbols, prohibition symbols,
command symbols, or notice symbols.
The Unit is designed in accordance with state-of-art technology and
accepted technical safety rules.
In spite of this, dangers for the user or third parties and impairments to the
Unit and other assets may unfold in the course of its use.
Poor knowledge about operations and maintenance may create damage to
persons or assets.
Operations and maintenance within the set rule boundaries, as well as
compliance with the following listed safety regulations, are necessary for the
protection of personnel and for the conservation of operational readiness.
Personnel, who assemble, dis-assemble, start-up, operate, and maintain
the Units, must know and observe these safety regulations.
All work may only be performed by expert personnel trained for the task
assigned using those tools, fixtures, inspection means, and materials for
consumption as designed for.
Please observe all legal or otherwise committing regulations for accident
prevention and environmental protection.
Prior to task start-up, personnel assigned for tasks to the Unit must have
read the general and special safety notes, and have sufficiently become
acquainted with the operations of the Unit.
Please observe all safety and danger notes compiled on the Unit!
All safety and danger notes compiled on the Unit shall be held in full number
and be held a readable status.
No changes, assemblies, and re-fittings, which impact the safety of the Unit,
are allowed to be performed to the Unit without approval of the
manufacturer.
Please secure that only personnel, who are accordingly assigned for work
on the Unit, are deployed.
Third parties shall be held away from the Unit, and also be pointed to the
possible dangers.
