- 24 -
TSE-N 10.00 A. B.
599 50 84 90
EN
L D8
L D7
L D6
9h
L D8
L D7
L D6
6h
L D8
L D7
L D6
3h
-
Countdown of
StartTime
-
The StartTime is counted backwards, beginning with the adjusted value until 0h. Afterwards
the program starts automatically. (see description on page B 4 / subject Programstart)
-
The display is updated accordingly.
-
Display of StartTime:
9h to 6h
6h to 3h
3h to 0h
0h / Start
(Other values possible, due to variant programming!)
-
Each activation of a pushbutton with in the 6 seconds of the program selection time, resets
the timer for the program start (where the pushbuttons are deactivated) again back to 6
seconds.
16. Input-Philosophy: Programstart till -end
Program start
-
After the end of the selected StartTimeDelay time or 6 seconds after the last program- or
optionbutton activation, the choosen program is automatically started.
-
From this time on, a delay time or program option can no longer be choosen.
To select a delay time, a restart of the machine is necessary.
Program run
-
During the program run, the following LED displays are highlighted:
o
Pushbutton-LED of the choosen program and options
o
Depending on the program phase, the related PPD-LED LD9 - LD11
-
The program cycle is described separetely in chapter Program cycles.
Program end
-
The End of program is displayed by PPD-LED End
-
The acknowledge LED of the program and, if choosen, of the option button(s) remain ON.
-
After reaching the program end, the actual program can be deleted by
either opening the door or switching OFF the machine by the ON/OFF button S0.
-
If the program was deleted by opening the door, the maschine is automatically in pre-start
mode, if the door is closed again, this means, that immediately a new program could be
choosen.
