Advantech PPC-102, Руководство пользователя

Страница: 30 / 126

16 PPC-102 User's Manual
2.3 Installing Options
2.3.1 Installing a primary 2.5" HDD (internal)
You can attach one enhanced Integrated Device Electronics (IDE) hard
disk drive to the PPC-102's internal controller which uses a PCI local-bus
interface. The advanced IDE controller supports faster data transfer rates
and allows the IDE hard drive to exceed 528 MB. The following are
instructions for installation:
1. Detach the rear panel and remove.
2. Place the HDD in the appropriate location inside the PPC-102, and
tighten the screws.
3. Connect the cable included in this package (1x44-pin to 1x44-pin)
from the HDD to the PC board (CN1). Make sure that the red/blue
wire corresponds to pin 1 on the connector, which is labeled on the
board. Plug the other end of the cable into the enhanced IDE hard
drive, with pin 1 on the cable corresponding to pin 1 on the hard
drive.
Warnings:(1) Plug the other end of the cable into the HDD, with
pin 1 on the cable corresponding to pin 1 on the hard
drive. Improper connection will damage the HDD.
(2) Be careful not to damage the CPU board with your
tools!
(3) The PCM-5865 board can accept installation of two
hard disks. However, the compact housing of the
PPC-102 has room for only one IDE HDD.
(4) Install two hard disks only if dictated by your own
special requirements, or as a test. To install two disks,
connect the single end of the appropriate cable to the
PCM-5865 board, and connect the other two
ends to each hard disk. When connecting two drives,
one must be configured as the master and one as the
slave. This is done using the jumpers on the drives.
For installations involving only one drive, set the drive
as the master.