Advance acoustic ADVANCE RS 501, Руководство по обслуживанию

Страница: 85 / 155

ENGLISH SERVICE MANUAL
82 33019746(2)2010-03 RS 501
MOTORE KUBOTA V1505T
FUEL HOSE AND FITTING CHECK
Empty the hopper (3); if it contains a small quantity of waste, it is not necessary to dump it. 1.
Drive the machine on a solid and level ground, then engage the parking brake with the lever (66). 2.
Lift the hopper (3), according to the procedure shown in the Instructions for use Manual. 3.
Turn the ignition key (76) to OFF position and remove it. 4.
Open the left door (18) by releasing the fasteners (19) with the supplied key. 5.
Remove the locking pins (28) from the housings (29) and place them into the holes (30). 6.
Empty the dust control system water tanks (7 and 16) according to the procedure shown in the relevant paragraph. 7.
Remove the screw (42) and open the left tank (7). 8.
WARNING!
Open the tanks (7 and 16) only if they are empty: Each tank contains 264.5 lb (120 kg) of water approximately.
Check the fi tting seal on the fuel fi lter (A) and on the injection pump (D). Replace if necessary. 9.
Check the seal of the lower fi tting (G) and upper fi tting (H) on the fuel tank (F). Replace if necessary. 10.
Check the integrity of the fuel system hoses on the fuel fi lter (A) and on the injection pump (D): 11.
Fuel fi lter - fuel tank hose (B) •
Fuel fi lter - injection pump hose (B) •
Injection pump - injectors hose (E) •
Engine body - fuel tank hose (F) •
If the clamps are loose, apply oil on the clamp screw and then tighten the clamp.
If the hoses are worn and/or damaged, replace them together with the clamps.
Perform steps 3, 4, 5, 6 and 8 in the reverse order.
12.
If necessary, fi ll the dust control system water tanks according to the procedure shown in the Instructions for use Manual. 13.
A
C
D
E
F
B
F
H
G
S341033