Advance acoustic ADVANCE RS 501, Руководство по обслуживанию

Страница: 74 / 155

SERVICE MANUAL ENGLISH
RS 501 33019746(2)2010-03 71
IMPIANTO DI TRAZIONE
ENGINE START-UP INHIBITION SYSTEM SENSOR DISASSEMBLY/ASSEMBLY
Disassembly
Proceed as shown in the “Reverse gear buzzer sensor disassembly/assembly” paragraph. 1.
Assembly
Proceed as shown in the “Reverse gear buzzer sensor disassembly/assembly” paragraph. 2.
WHEEL REMOVAL/INSTALLATION
Preliminary operations
Turn the ignition key (76) to OFF position and remove it. 1.
Engage the parking brake with the lever (66). 2.
Check that the machine cannot move with one wheel lifted (the parking brake operates only on the front wheels). If necessary 3.
keep the machine stationary by placing wedges on the wheels contacting the ground.
Remove the wheel according to the following procedure.
4.
Rear wheel removal/installation
Place the jack (A) (not equipped) under the relevant housing (B) in the rear axle (C), as shown in the fi gure. 5.
Carefully activate the jack (A) with the lever (E) and lift the wheel (D) until it is slightly detached from the ground. 6.
Remove the mounting nuts, then remove the wheel (D). 7.
Install the wheel (D) by performing steps from 5 to 7 in the reverse order. 8.
Wheel mounting nut tightening torque: 295 lb·ft (400 N·m)
Front wheel removal/installation
Place the jack (A) (not equipped) under the relevant housing (G) on the machine side sill, in front of the wheel (H), as shown in 9.
the fi gure.
Carefully activate the jack (A) with the lever (E) and lift the wheel (H) until it is slightly detached from the ground.
10.
Remove the mounting nuts, then remove the wheel. 11.
Install the wheel by performing steps from 9 to 11 in the reverse order. 12.
Wheel mounting nut tightening torque: 295 lb·ft (400 N·m)
WARNING!
Use a suitable jack with a minimum lifting capacity of 4,409 lb (2 ton).
B
E
F A
D
C
A
H
G
E
F
S341026