Adtech ADT-HC8200, Руководство пользователя

Страница: 86 / 97

Chapter 4 Instruction System
4-6
I and J are increasing value of the circle center related to starting point at X axis and Y axis direction. In
order to simplify the compilation of the processing files manually, you can just enter I50 J0 if you want to compile
a circle with a diameter of 100mm; and enter I75 J0 if you want to compile a circle with a diameter of 150mm.
Figure 4.3.4.1 Arc cutting
4.3.5 Other G commands
G91/G90 Relative/absolute coordinates
G41/G42 Left/right slotting compensation
G40 Cancel slotting compensation
4.3.6 M commands
The system is customized with a supplementary command.
M44. This command is used to set the time delay. When the program executes this command, the system will
delay according to the set time before executing the next code.
4.3.7 EIS command
Is
、
Js command
Is – Displacement of the X coordinate of the end point related to the starting point of the current
segment, unit: mm;
Js – Displacement of the Y coordinate of the end point related to the starting point of the current
segment, unit: mm;