Adtech ADT-HC8200, Руководство пользователя

Страница: 58 / 97

Chapter 3 Function and Operation
3-34
move the cursor to the parameter you want to modify. After setting, save the modified parameter.
3.2.4.3 F3
Password
Under System setting interface, press F3 and enter the correct password, then press Enter to enter the
interface as shown in 3.2.4.3.1. Parameters in this interface are very important and should not be modified unless
necessary.
Figure 3.2.4.3.1 Password set parameters
Machine
1. X Position: you can select Transverse axis or Rail axis according to your requirements.
2. Up arrow direction: you can define the axis according to your requirements, mainly depending on
placement of the machine.
3. Right arrow direction: you can define the axis according to your requirements. If X axis is defined for
up arrow, then only Y axis can be defined for right arrow.
4. Servo enable: select Yes if you need the software to enable the servo, otherwise select No.
5. Zeroing direction: Define according setting of the zero point.
6. Pulse output method: you can select double pulse or pulse + direction.
7. X axis drive direction: you can select forward or backward according to your requirement.