Adtech ADT-HC8200, Руководство пользователя

Страница: 32 / 97

Chapter 3 Function and Operation
3-8
preview it.
Figure 3.2.1.1.3 Perforation shape
Tips for operation
The parameter setting in the shape library is conditional according to the characteristics of the Part. As shown
in the figure, the radius of the circle cannot be larger than the radius of the arc outside it or the height from the
center of the circle to the bottom of the trapezoid, and the length of the bottom of the trapezoid cannot be smaller
then 2 times of the radius of the arc at top. If the parameters exceed the limit, the shape will not be composed
correctly. After setting the parameters, press F3 to preview or Tab to preview automatically, if the parameters
exceed the limit, the system will prompt.
Take the parameter setting interface of the “convex polygon with a hole” as an example, if the radius of the
circle is modified to 100 and F3 is pressed, system will prompt “Arc radius too large” and the parameter will
return to original value automatically.
The option “Inlet arc radius” is added in the interface to avoid perforating at the edge of the part which may
influence processing quality. Some shape requires the inlet line, which is used to convenience the operation, and
make sure the cutting quality is not influenced. The options “Idle move X” and “Idle move Y” can be found in all
shapes in order to convenience the user to set the original place of the cutting torch.
Press Tab to select a parameter to set while setting the parameters.