Adtech ADT-HC8200, Руководство пользователя

Страница: 53 / 97

XT20100820 HC8200 Flame Cutting Machine User’s Manual
3-29
Whether or not to save the value after calibration.
Select cut torch
To select cut torch used in cutting process.
3.2.4.2 F2
Cutting
The system currently supports oxygen gas cutting, plasma cutting, powder spray marking and plasma
marking.
Oxygen gas
Figure 3.2.4.2.1 Oxygen gas cutting parameters
1. Torch up time before start cutting:The time torch up before start cutting.
2. Ignition time: The time during which the output signal remains valid for every ignition.
3. Low preheat time. For the equipment with low preheating function, the time during which the low
preheating signal remains valid before high preheating. This time can be prolonged, cancelled or modified.
4. High preheat time. The time of the high preheating signal before every perforation. This time can be
prolonged, cancelled or modified.
5. Perforation time. The time delay during the period after the cutting oxygen is opened up and the torch
drops to the height for cutting. This time can be prolonged, cancelled or modified.
6. Move perforation time. The time for moving perforation after starting perforating.
7. Creep time. The time during which the equipment runs in creep speed after perforation. The creep speed
can be set in speed parameter interface and is shown as the percentage of the cutting speed. After the creep time,
the equipment will accelerate to the set cutting speed. During creeping, the cutting surface can be heated for a