Adtech ADT-HC8200, Руководство пользователя

Страница: 57 / 97

XT20100820 HC8200 Flame Cutting Machine User’s Manual
3-33
spray marking process.
3. Use flame cutting control in spray marking process. If Yes is selected, the powder spray craftsmanship is
the same with the oxygen gas ignition craftsmanship, otherwise only powder mixing and ignition craftsmanship
will be applied.
To set the parameters on the right, press F3 and then press Tab to switch among different parameters and
move the cursor to the parameter you want to modify. After setting, save the modified parameter.
Plasma mark
Figure 3.2.4.2.4 Plasma marking parameters
1. Mark arc strike time. The time delay for each marking arc striking.
2. Mar arc OFF time. The time delay for arc closing while arc blowout.
3. Mark up time. The time for marking rising after completion of marking.
4. Mark down time. The time for marking dropping after completion of marking.
5. Ignition for arc strike. Whether or not to use the ignition signal for arc striking while marking.
6. Plasma control for mark process. Whether or not to use plasma arc striking craftsmanship for marking
arc striking craftsmanship.
7. Use arc feedback signal. Whether or not use the arc feedback signal while marking arc striking.
To set the parameters on the right, press F4 and then press Tab to switch among different parameters and