ADT GSMVLP-ADT, Инструкция по установке и программированию

Страница: 7 / 24

– 7 –
Using a 7720P Programming Tool
After the GSMVLP-ADT has been installed in the ADT QuickConnect 3000, connect the 7720P
Programming Tool as shown in Figure 5. The GSMVLP-ADT powers the 7720P Programming Tool via
the programming jack. Each key of the 7720P has two possible functions: a normal function and a Shift
function.
•
To perform a normal key function, simply press the desired key.
•
To perform a Shift function, press the [shift] key, and then press the appropriate key.
The prompts in this document reflect use of the 7720P Programming Tool. Table 1 lists each normal
and shift key function.
7720P PROGRAMMING JACK
MESSAGE STATUS LEDs
MINIMUM SIGNAL STRENGTH LED
TEST
MESSAGE/REGISTRATION
SWITCH
GSMVLP-004-V0
A B C
D E F
S T X
Xmit
Shift
Space Enter
Shift
N / Y
BS / ESC
/
7720 PROGRAMMING TOOL
#
0
1 2 3
4 5 6
9 8 7
Figure 5 – 7720P Connection
Table 1 – 7720P Normal and Shift Key (shift LED lit) Functions
KEY NORMAL KEY FUNCTION SHIFT KEY FUNCTION
BS/ESC [BS]: Press to delete entry [ESC]: Press to quit program mode; also can reset
programming defaults*
↓
/
↑
[
↓
]: Scroll down programming [
↑
]: Scroll up programming
N/Y [N]: Press for "NO" answer [Y]: Press SHIFT-Y for "YES" answer
SHIFT Press before pressing a SHIFT key function. Will light SHIFT LED. LED goes out once a key is pressed.
Press again for each SHIFT function desired.
1/A [1]: For entering the number 1 [A]: For entering letter A
2/B [2]: For entering the number 2 [B]: For entering letter B
3/C [3]: For entering the number 3 [C]: For entering letter C
4/D [4]: For entering the number 4 [D]: For entering letter D
5/E [5]: For entering the number 5 [E]: For entering letter E
6/F [6]: For entering the number 6 [F]: For entering letter F
7/S [7]: For entering the number 7 [S]: For entering letter S
8/T [8]: For entering the number 8 [T]: For entering letter T
9/X [9]: For entering the number 9 [X]: For entering letter X
SPACE [SPACE]: For scrolling option list No SHIFT function
0 [0]: For entering the number 0 No SHIFT function
#/ENTER [#/ENTER]: Starts programming
mode; Press to accept entries No SHIFT function
*Active only when the "Exit Programming Mode" prompt is displayed.