ADT GSMVLP-ADT, Инструкция по установке и программированию

Страница: 18 / 24

– 18 –
FAULT, RED
MESSAGE, YELLOW
STATUS, GREEN
GSMVL-003-V0
A
FAULT, RED
MESSAGE, YELLOW
STATUS, GREEN
B
Figure 8 – A Configured GSMVLP-ADT Status Display (A) and
an Unconfigured GSMVLP-ADT Status Display in Normal Operating State (B)
FAULT, RED
MESSAGE, YELLOW
STATUS, GREEN
GSMVL-004-V0
4 3 2 1
MAXIMUM SIGNAL
STRENGTH, GREEN
Figure 9 – LED Sequence for a Configured GSMVLP-ADT Message Transmission
CENTRAL STATION MESSAGES
The following messages are sent to the Central Station by the GSMVLP-ADT module for the conditions
listed below.
Table 4 – GSMVLP-ADT Central Station Messages
Alarm Condition
ECP Mode
Alarm Code
ECP Mode
Restore Code
Power On Reset E339 C0803
ECP Supervision E355 C0000 R355 C0000
Communication Path Restore R350 C0951
Test 5555 5555 9
Note: The control panel sends its own general code (E353) for a trouble condition.
GSMVLP-ADT DOWNLOADING
General Information
The GSMVLP-ADT can be used to provide high-speed up/downloading to QuickConnect 3000 control
panels over the GPRS network via ECP
communication. This allows site maintenance
independent of central station monitoring, and modification to sites globally.
U U U UL
L L L
Downloading may only be performed if a technician is at the site.