ADOS S.R.L. Buccinasco (MI)
492-MTU10006
Rev. 4
Page 48 of 49
6.6
System Initialization
The instrument can be reset to the default configuration by mean of the System initialization function.
To enter the system initialization mode , the user must enter the instrument control mode and use the
F
key
to select the modality:
S Y S
I N I T
and press the
E
key.
The instrument will ask for password and, if correct, the following message will be displayed:
*
I N I T
*
Press the
E
key to request to start the sequence and the instrument prepares to receive the confirmation
command:
O K
I N I T ?
flashing
Press the
E
key to confirm the selection made and the instrument initializes the parameters and restarts
automatically.
Press the
C
key to cancel the initialization request and return to the instrument control menu.
6.6.1
Switch controlled initialization
Initialization by switch can only be performed at power-on time.
The procedure is the following:
?
DIP switch SW1-4 must be ON prior to power on
?
The display shows the message:
O K
I N I
flashing
?
if the switch is setted to OFF in less than 5 seconds the initialization is carried out and the message on
display changes to
I N I T
flashing
and stays in this condition as long as a key is pressed, thus proceeding with startup sequence.
?
if the switch is left unchanged the instrument proceeds with normal startup sequences