bandwidth, and level using multiple bands. The effect includes three fully parametric mid
bands, a high band, and a low band. The low and high bands are shelving filters, by
default. Gain is constant over frequency. The Cut control switches the low and high band
from shelving to cutoff filters. Gain is fixed to –12 dB per octave and is deactivated in
cutoff mode.
Use the graphical controls in the Custom Setup view, or adjust values in the Individual
Parameters view. In the Custom Setup view, you can control the parameters of the filter
bands in the Frequency window by dragging band handles. Each band includes a control
for Frequency and Gain. Mid bands include two additional controls for adjusting the
Qfactor.
Using Help | Contents | Index Back 282
Adobe Premiere Pro Help Applying Effects
Using Help | Contents | Index Back 282
Frequency
Specifies the amount by which to increase or decrease the band (between 20
and 2000 Hz).
Gain
Specifies the amount by which to increase or decrease the band (between –20 and
20 dB).
Cut
Changes the functionality of the filter from shelving to cutoff.
Q
Specifies the width of each filter band (between 0.05 and 5.0 octaves).
Output
Specifies the amount of gain to compensate for increases or reductions of
frequency bands on the output gain of the EQ.
Fill Left, Fill Right
The Fill Left effect duplicates the right channel information of the audio clip and places it
in the left channel, discarding the original clip’s left channel information. The Fill Right
effect duplicates the left channel information in the right channel, discarding the existing
right channel information.Apply to stereo audio clips only.
Highpass, Lowpass
The Highpass effect removes frequencies below the specified Cutoff frequency. The
Lowpass effect eliminates frequencies above the specified Cutoff frequency.
Invert
The Invert effect inverts the phase of all channels.
MultibandCompressor
The MultibandCompressor effect is a three-band compressor with controls for each band.
Use this effect instead of the compressor in Dynamics when you need a softer sounding
compressor.
Use the graphical controls in the Custom Setup view, or adjust values in the Individual
Parameters view. The Custom Setup view displays the three bands (low, mid, high) in the
Frequency window. You control the gain for each band by adjusting handles for makeup
gain and frequency range. The handles of the center band determine the crossover
frequency of the bands. Drag the handles to adjust the corresponding frequency.
The MultibandCompressor effect includes the following controls:
Solo
Plays the active band only.
MakeUp
Adjusts the levels, in decibels.
BandSelect
Selects a band.
Crossover Frequency
Increases the range of frequencies for the selected band.
Output
Specifies the output gain adjustment to compensate for the reduction or
increase in gain caused by compression. This helps to preserve the mix of the individual
gain settings.
Use the following controls for each band:
Threshold 1-3
Specifies the level (between –60 and 0 dB) the incoming signal must
