ADLINK Technology NuPRO-598 Series, Руководство пользователя, Страница: 58 / 90

50
•
BIOS Configuration
Throttle Duty Cycle
When the system enters Doze mode, the CPU clock runs only part of the
time. You may select the percent of time that the clock runs.
75.0% 75.0% time that the CPU clock runs
62.5% <Default> 62.5% time that the CPU clock runs
50.0% 50.0% time that the CPU clock runs
37.5% 37.5% time that the CPU clock runs
25.0% 25.0% time that the CPU clock runs
12.5% 12.5% time that the CPU clock runs
ZZ Active In Suspend
The ZZ signal is used to power down a cache’s data SRAMs when the clock
logic places the CPU into the stop clock.
Enabled Enable the ZZ signal to power down cache’s SRAM
Disabled
<Default> Disable the ZZ signal when in suspend mode
PCI/VGA Act-Monitor
When enabled, any video activity restarts the global timer for Standby mode.
The default setting is
Enabled .
Soft-Off by PWR-BTTN
This field defines the power-off mode when using an ATX power supply.
There are two modes :
Instant-Off
<Default> The mode allows powering off immediately upon pressing
the power button
Delay 4
Sec
The system powers off when the power button is pressed
for more than four seconds or places the system in a very
low-power-usage state, with only enough circuitry receiving
power to detect power button activity.