48
•
BIOS Configuration
PM Control by APM
This field allows you to use the Advanced Power Management device to
enhance the Max. Power Saving mode and stop the CPU’s internal clock.
The default setting of this field is
Yes
.
Video Off Method
This field defines the Video Off features. There are three options.
V/HSYNC + Blank
<Default>
This selection will cause the system to turn off the
Vertical and horizontal synchronization ports and
Write blanks to the video buffer
DPMS
Allows the BIOS to control the video display board if
it supports the DPMS feature
Blank Screen
This option only writes blanks to the video buffer
Video Off After
As the system moves from lesser to greater power-saving modes, select the
mode in which you want the monitor to blank. There are four options.
NA
The monitor will not be blank
Doze
When the system enter Doze mode, the Video off.
Standby <Default>
In Standby mode, the Video off.
Suspend
In Suspend mode, the Video off.
Modem Use IRQ
This field names the interrupt request (IRQ) line assigned to the modem (if
any) on your system. Activity of the selected IRQ always awakens the
system. By default, the IRQ is set to
3
.
Doze Mode
When enabled, and after the set time of system inactivity, the CPU clock will
run at a slower speed while all other devices still operate at full speed.
Disabled
<Default>
Don’t Enter the Doze mode
1 Hour
After 1 hour of system inactivity, enter Doze mode
40 min
After 40 min of system inactivity, enter Doze mode
30 min
After 30 min of system inactivity, enter Doze mode
20 min
After 20 min of system inactivity, enter Doze mode
12 min
After 12 min of system inactivity, enter Doze mode
8 min
After 8 min of system inactivity, enter Doze mode
4 min
After 4 min of system inactivity, enter Doze mode
2 min
After 2 min of system inactivity, enter Doze mode
1 min
After 1 min of system inactivity, enter Doze mode
Содержание NuPRO-598 Series
