Industrial
Electronic Devices
ADFweb.com S.r.l.
User Manual
RS485 / RS232 / Ethernet
Document code: MN67038_ENG Revision 2.003 Page 35 of 42
Note:
When you install a new version of the software, if it is the first time it is better you do the update of the Firmware in the HD67038
device.
Note:
When you receive the device, for the first time, you also have to update the Firmware in the HD67038 device.
Warning:
If Fig. 9 appears when you try to do the Update try these points before seeking
assistance:
Check if the serial COM port selected is the correct one;
Check if the serial cable is connected between the PC and the device;
Try to repeat the operations for the updating;
If you are using a USB
RS232 converter try with a native COM port or change
the converter;
Try to repeat the operations for the updating;
Try with another PC;
Try to restart the PC;
Check the LAN settings;
Check the Wi-Fi settings;
If you are using the program inside a Virtual Machine, try to use in the main
Operating System;
If you are using Windows Seven, Vista and 8 make sure that you have the
administrator privileges;
In case you have to program more than one device, using the "UDP Update", you have to cancel the ARP table every time you
connect a new device on Ethernet. For do this you have to launch the "Command Prompt" and write the command "arp -d". Pay
attention that with Windows Vista, Seven, 8 you have to launch the "Command Prompt" with Administrator Rights;
Pay attention at Firewall lock.
In the case of HD67038 you have to use the software “SW67038”:
www.adfweb.com\download\filefold\SW67038.zip
.
Figure 9: “Protection” window
