INSTALLATION
Measure the distance between the cooking
surface and the bottom of the range hood. A
distance of 27” to 30” is recommended*.
*
Due to different ceiling height configurations, the
recommended height may not be applicable
.
12
a. Using references in the
Height & Clearance
diagram, determine and clearly mark the
centerline
on the bottom of the cabinet.
center the hood beneath the cabinet and flush with the front of the cabinet.
b. Draw electrical wires through cabinet access opening on top of the range hood (refer to
figure 3),
c. From inside the hood, place hood mounting screws in the exact center of each knockout
holes
and secure to the cabinet bottom. Tighten all screws until secure. Be careful when
using electrical
screwdriver in order not to damage the range hood. Connect and secure
the 8’’ round metalduct.
CAUTION: Make certain the range hood is secure before releasing!
For safet y purpose, pre-drilled mount ing holes are provided t hrough t he back of t he hood. For a
Step 1
: Determine the venting method and proceed if you would like tovent
VERTICALLY
.
(see INSTALLATION DIAGRAMS on page 7):
more secure inst allat ion,use as many mount ing holes as needed t o secure from t he inside of hood.
Use 7” round st eel pipe (follow building codes in your area) t o connect t he exhaust on t he hood t o
Step 3 :
Step 5 :
St ore excess w ires in t he w iring box.
St ep 2 :
Figure
5
Figure
4
(black,w hit e andgreen) t o house w ires and cap w it h w ire connect ors.Connect according t o colors
(i.e. black t o black, w hit e t o w hit e, and green t o green) as show n in Figure 4.
t he duct w ork above.Use silver t ape or duct t ape t o make all joint s secure and air t ight . Refer t o Figure 5.
SAFETY WARNING: Risk of elect rical shock. t his range hood must be properly grounded.M ake sure t his is
done by qualified elect rician in accordancew it h all applicable nat ional and local elect rical codes. Before
connect ing w ires,sw it ch pow er off at service panel and lock service panel t o prevent pow er from being
sw it ched on accident ally.
Step 4 :
Connect t he range hood t o a designat ed st andard out let or cut off t he plug and connect t hree w ires