ADEMCO RapidEye plus, Инструкция по установке и настройке

Страница: 18 / 43

Rapid Eye Remote Video Unit Installation and Setup Guide
12
3.0 Installing the Remote Video Unit
1. Strip approximately 1/4 inch of insulation from the alarm wire to be
connected to the Remote Video Unit.
2. Connect each alarm wire to the screw type terminal connector on the
ALARM terminal strip: one wire to the numbered terminal connection
you choose and the other wire to ground. There must be no bare wire
visible at the rear panel when the alarm wire is connected to the Remote
Video Unit.
3.3 Control Output Connections
The operator activates these outputs. Examples of this are turning on lights,
warning bells, or power locks. Relays to control these devices may be
connected as follows:
1. Strip approximately 1/4 inch of insulation from the wire to be connected
to the connector.
2. Connect each relay control wire to the screw type terminal connector on
the CONTROL OUTPUTS terminal strip: one wire to ground and the
other wire to the numbered connection you choose. There must be no
bare wire showing at the rear panel when the output control wire is
connected to the Remote Video Unit.
Each output device can draw up to 24 mA.
3.4 Communication via LAN
If your system is configured for a Local Area Network (LAN) your Remote
Video Unit contains a Network Interconnect Card (NIC) as well as TCP/IP
drivers that allow you to connect to the LAN. You must first select an IP
address, then program it in your Remote Video Unit as follows:
Selecting an IP Address
The IP address is the unique address permanently assigned to your Remote
Video Unit. In addition to supplying an IP address, you may also have to
configure a router and subnet mask.
Entering the IP Address
Use the Rapid Eye Remote User Interface (RUI) software to enter the IP
address into your Remote Video Unit. The RUI is text-based software that
allows a terminal operator to view and change configuration parameters in
the Remote Video Unit.