ADEMCO RapidEye plus, Инструкция по установке и настройке

Страница: 12 / 43

Rapid Eye Remote Video Unit Installation and Setup Guide
6
2.0 Rear Panel Connectors
(cont'd)
Connector
Description
Alarm/Control Inputs These screw terminal connectors are used for
alarm inputs and ground connections. Alarm
inputs are factory configured as either NO
(normally open), NC (normally closed), or 2.2K
EOL (end of line) resistor. They are labeled as
follows (refer to Figure 2):
1 G 2 G 3 G 4 G 5 G 6 G 7 G 8 G
9 G 10 G 11 G 12 G 13 G 14 G 15 G 16 G
The alarm control inputs are TTL type (having a
minimum high level of +2.4 volts and maximum
low level of +0.4 volts).
The numbers refer to the alarm signal inputs,
and the ‘G’s refer to the associated ground
connection. All alarm inputs must be referenced
to the ground connection(s) of the Remote Video
Unit.
Control Outputs These outputs provide the means to control
external devices such as lights, sirens, or locks.
They are labeled as follows (refer to Figure 2):
1 G 2 G 3 G 4 G 5 G 6 G 7 G 8 G
The numbers refer to the control outputs, and
the ‘G’s refer to the associated ground
connection. All control outputs must be
referenced to the ground connection(s) of the
Remote Video Unit.
The outputs are at TTL logic levels that do not
drive devices directly, but control relays that
activate these devices. These devices can be
purchased separately from a number of security-
related OEMs that serve these extended
functions.
(cont’d on next page)