ADC ML-96, Руководство по установке

Страница: 3 / 24

113362 - 25 www.adclaundry.com 3
IMPORTANT
You must disconnect and lockout the electric
supply and the gas supply or the steam supply
before any covers or guards are removed from
the machine to allow access for cleaning,
adjusting, installation, or testing of any
equipment per OSHA standards.
Please observe all safety precautions displayed
on the equipment and/or specified in the
installation manual included with the dryer.
CAUTION
Dryer(s) should never be left unattended while
in operation.
“Caution: Label all wires prior to disconnection
when servicing controls. Wiring errors can cause
improper operation.”
«Attention: Au moment de l’entretien des
commandes, étiquetez tous les fils avant de les
débrancher. Des erreurs de câblage peuvent
entraîner un fonctionnement inadéquat.»
WARNING
Children should not be allowed to play on or near
the dryer(s). Children should be supervised if
near dryer(s) in operation.
Under no circumstances should the dryer door
switch(es), lint door/drawer switch(es), or heat
safety circuit(s) ever be disabled.
DO NOT MODIFY THIS APPLIANCE.
The dryer must never be operated with any of
the back guards, outer tops, or service panels
removed. Personal injury or fire could result.
The dryer must never be operated without the
lint filter/screen in place, even if an external lint
collection system is used.
If the hi-limit switch trips, a service call is required
to investigate the reason and resolve the issue.
FOR YOUR SAFETY
Do not dry mop heads in the dryer. Do not
use dryer in the presence of dry cleaning
fumes.
The dryers must not be installed or stored in an
area where it will be exposed to water and/or
weather.
The wiring diagram for the dryer is located in
the front electrical control box area.
List of Acronyms _____________________________
D.M.S. Drill Measurement Size
DSI Direct Spark Ignition
HVAC Heating, Ventilating, and Air-Conditioning
in WC Inches of Water Column
L.E.D. Light Emitting Diode
OSHA Occupational Safety and Health Administration
R.M.A. Return Material Authorization
UL Underwriters Laboratory
Table of Contents ____________________
In the State of Massachusetts, the following
installation instructions apply:
■
Installations and repairs must be performed by
a qualified or licensed contractor, plumber, or
gasfitter qualified or licensed by the State of
Massachusetts.
■
If using a ball valve, it shall be a T-handle type.
Safety Precautions .............................. 4
Specifications ...................................... 6
Installation Procedures ...................... 8
Location Requirements .............................................. 8
Unpacking / Setting Up ............................................. 8
Dryer Enclosure Requirements ................................. 9
Fresh Air Supply Requirements .............................. 10
Exhaust Requirements ............................................ 10
Electrical Information ............................................... 12
Gas Information ........................................................ 13
Water Information ..................................................... 15
Preparation for Operation / Start-Up ........................ 17
Preoperational Test .................................................. 17
Preoperational Instructions ...................................... 18
Shutdown Instructions ............................................. 18
Service / Parts Information .............. 19
Service ...................................................................... 19
Parts ......................................................................... 19
Warranty Information ....................... 19
Returning Warranty Cards ....................................... 19
Warranty ................................................................... 19
Returning Warranty Parts ........................................ 19
Routine Maintenance ........................ 20
Cleaning ................................................................... 20
Adjustments ............................................................. 20
Lubrication ................................................................ 20
Procedure for Functional Check
of Replacement Components ........... 21
Data Label Information ..................... 22
Manual Reset Burner
Hi-Limit Instructions ......................... 23