Installation
150-712-200-02
8
July 26, 2000
HRE-712 List 1 and List 2
Pedestal or Small Pole Mounting the HRE-712 List 1
This procedure details how to mount the enclosure on a pole or pedestal where the pole is less than 7 inches
(17.78 cm) in diameter.
Have the following equipment ready before you begin this procedure:
•
Two
3
/
8
-inch (0.952 cm) lag bolts, 4 inches (10.16 cm) long minimum
•
Two
3
/
8
-inch (0.952 cm) washers
•
One wrench
•
One pencil
•
One drill with a
1
/
4
-inch (0.635 cm) bit
To mount the enclosure, follow these steps:
1
Select a mounting location on the pedestal or pole.
2
Remove the mounting bracket from the HRE-712 by removing the four bolts that connect each sideplate as
shown in
3
Position the mounting bracket against the pedestal or pole. The mounting bracket must be positioned so the
stub will be down. Mark the location of the two center mounting holes. Remove the mounting bracket.
4
Drill two
1
/
4
-inch (0.635 cm) diameter holes at the locations marked in
. Each hole should be drilled
approximately 3 inches (7.62 cm) into the pole.
5
Start a lag bolt in the top center bottom mounting hole by tightening the lag bolt into the pole or pedestal
approximately
2
/
3
- inch (1.70 cm).
6
Insert a lag bolt into the bottom hole of the mounting bracket and tighten the bolt.
7
Secure the enclosure bracket to the pole or pedestal by tightening the two lag bolts.
8
Reattach the enclosure to the mounting bracket and torque the four mounting bracket bolts 30 to 40
inch-pounds (3.4 to 4.5 Newton-meters).
9
If the cable stub connects to an underground cable, dress the cable down the pole or pedestal to the splice case.
If the cable stub connects to an aerial cable, form a drip loop in the cable and dress it up the pole or pedestal
to the splice case.
