ADB DTC, Инструкция по эксплуатации

Страница: 24 / 41

AM.04.510e - Edition 1.5 24
Maintenance
5.2.4 Replace optical assy
Parts
- Optical assy
- Optical assy screws.
- Gasket for optical assy
- Gasket of the pressure release screw
Tools
- Lubricant A. See § 7.4.
Disassemble
1. Remove the upper cover assy. See § 5.2.2.
2. Remove the pressure release screw (A).
3. Dispose of the gasket of the pressure
release screw.
4. Remove the optical assy screws (B).
5. Dispose of the optical assy screws.
6. Remove the optical assy (C).
7. Disconnect the wires from the optical assy to the PCB (E). Pull the wires, not the connector.
8. Remove the gasket (F).
9. Dispose of the gasket.
Assemble
Prepare
1. Make sure that all parts are clean.
2. Pay special attention to the part where the
gasket must fit (A).
3. Lubricate the new gasket (B). Use
lubricant A.
4. Install the new gasket.
CAUTION
Always dispose of the gaskets and the screws when you disassemble the
optical assy.
CAUTION
The optical assy is
connected to the PCB. If
you pull too hard, you can
damage the PCB.
Note
Put a screwdriver in the
notches (D).
C
A
B
F
D
E
B
A
B