ADB Safegate FCU-1-in-1, Руководство пользователя

Страница: 93 / 110

Table 40: LMC PCB dip-switch settings. (continued)
Dip-switch
bank
Type Setting Use Remarks
SW5 Dip 1 > 6 Number of equipments in the system Manual configuration SW4
7 Not in use
8
OFF To disable the use of the dongle.
ON To enable the use of the dongle
1) Initiates the data E²PROM. The LMC stores the system parameters in an E²PROM. At first power-up or when the system must be
completely reconfigured, it is possible to clear the E²PROM and return to the default factory settings. To do this, put the switch to ON,
power down the LMC and turn it ON again after 5 s. Set the switch back to OFF. If this is not the case, the E²PROM will be cleared at the next
power cycle.
2) Lock to boot. This switch is always OFF in a functioning system. Use this only if there is a major problem when you upload a new
application code.
9.3.4 LEDs
Table 41: Functions.
LED Function Status Notes
DS1 Isolated supply Bus A ON
DS2 Isolated supply Bus B
DS3 Isolated supply local bus.
DS4 Reserved For future use
DS5 RUN. One flash per s Higher rate during software upload.
DS6 Rx local bus Normally OFF. Lights up momentarily
during transmission or reception
If one of these LEDs is permanently
OFF, there is no traffic on the
corresponding bus.
DS7 Tx local bus
DS8 Rx Bus A
DS9 Tx Bus A If one of these LEDs is permanently
ON, there may be polarity inversion on
the bus.
DS10 Rx Bus B
DS11 Rx Bus A
9.4 Multiwire - PCB1486
Note
It is impossible to attribute the same function to more than one terminal.
UM-4019_AM02-620e, Rev. 3.0, 2020/05/12 83
Copyright
©
ADB Safegate, All Rights Reserved