Replacing a Power Supply Module
Snap Server 700i Series
2
Field Service Documentation
Copyright © 2007, Adaptec, Inc. All rights reserved. Information in this document is subject to change without notice and does not represent
a commitment on the part of Adaptec or any of its subsidiaries.
3
To release the module, pull the handle up, push the red latch to the right, and
then pull the handle towards you.
4
Grasp the handle and pull the module out of the chassis, catching the body of the
module in the other hand, and set it aside.
Inserting a Replacement Power Supply Module
1
Resting the body of the module in one hand while holding the handle with the
other, insert the module and slide firmly into place. Make sure it is seated all the
way into the chassis.
2
The latch will lock the module into place. Fold the handle down against the
module.
3
Insert the power cord and connect to a power source. The LED should be solid
green.
Note
If you have a dual power supply and do not immediately insert the power
cord and connect it to a power source, an alarm will sound until you do.
Release latch
