Field Service Documentation
3
Copyright © 2007, Adaptec, Inc. All rights reserved. Information in this document is subject to change without notice and does not represent
a commitment on the part of Adaptec or any of its subsidiaries.
Snap Server 700i Series
Replacing DIMMs
Replacing a DIMM
1
Remove the Caution label covering the DIMM(s).
As stated on the label, only replace the DIMM with another DIMM supplied by
Adaptec.
2
Remove the DIMM.
To release the DIMM from its slot, press the white latches on both sides of the
module down and outward. Grasping the edges of the module, lift it out of its
slot and set it aside.
3
Insert the new module into the same slot.
Grasping only the edges of the module, insert it into the same slot, avoiding
contact with metal surfaces on the module.
4
Push the module in until the latches mostly engage. Then secure the latches to
close the final gap.
Remove DIMM
Latch
Latch
Front of Server