Replacing a Disk Drive
Snap Server 700i Series
4
Field Service Documentation
Copyright © 2007, Adaptec, Inc. All rights reserved. Information in this document is subject to change without notice and does not represent
a commitment on the part of Adaptec or any of its subsidiaries.
Replace the Front Bezel
1
Position the bezel so the tabs line up to slide under the top edge of the cover.
Make sure that the LED/LCD connector on the bezel matches up with the
connector on the chassis.
2
Press firmly to reattach the bezel.
You should hear a muted click when the latches lock.
Configure the Replacement Disk Drive
If the Pool was Protected by a Hot Spare
If the pool was protected by a hot spare, the hot spare is automatically incorporated
into the pool and takes over for the failed drive. Use your replacement drive to
create a new hot spare:
1
In the Enterprise View, select the iSCSI Storage Appliance associated with the hot
spare.
2
In the Physical Devices View, select the hot spare.
3
In the
Actions
menu, select
Delete hot-spare drive
, then select the pool with the
hot spare you want to delete.
4
Designate the new hot spare.
If the Pool was not Protected by a Hot Spare
When the failed drive is replaced, the new disk drive will automatically be detected
and the pool will begin rebuilding.
