Adaptec 1130U2 - Storage Controller RAID)- U2W SCSI 80 MBps, Инструкция по установке и эксплуатации оборудования, Страница: 28 / 82

4-4
ARO-1130U2 Installation and Hardware Guide
6
When the next menu appears, select a boot order for the new
array.
– Select Disk Array will be Boot Drive if you want your
workstation to boot from the new array. If you selected
Optimized for Data Protection
in Step 4, booting from an
array safeguards the information on your boot drive. (To
boot from an array, you must also install the operating sys-
tem software on the array, as described in later chapters.)
– Select Disk Array will not be a Boot Drive if you do not
want your workstation to boot from the new array.
7
When you have finished all these menu selections, wait while
ArrayConfigU2 creates the array. This may take a long time,
especially if the drives are large.
A message appears when the array has been created. An error
message appears if fewer than two drives are available or if
ArrayConfigU2 encounters some other problem. If this hap-
pens, install more drives or run ArrayConfigU2 again and use
the Custom Setup option.
8
When the array is created, exit ArrayConfigU2, remove the
ArrayConfigU2 diskette, and reboot the system. After you
reboot you can write data to the arrays. At this point, you can
make the array bootable as described in Making the Array Boot-
able on page 4-8.