Adaptec 1130U2 - Storage Controller RAID)- U2W SCSI 80 MBps, Инструкция по установке и эксплуатации оборудования, Страница: 22 / 82

3-2
ARO-1130U2 Installation and Hardware Guide
Running the Array1000 BIOS & Driver Selection
Utility
The Array1000 BIOS & Driver Selection Utility is provided on a
bootable floppy disk and runs under DOS as a stand-alone utility. A
simple-to-use interface prompts you through the process. Follow
these steps to run the Array1000 BIOS & Driver Selection Utility:
1
Insert the Array1000 BIOS & Driver Selection Utility diskette in
drive A and reboot your system. The utility starts
automatically and the initial Array1000 BIOS & Driver Selec-
tion Utility screen appears.
Note:
The initial Array1000 BIOS & Driver Selection
Utility screen identifies which Array1000U2 Family
Manager Set driver diskettes (Disk A or Disk B) is
required when you install the operating system driver,
as explained in Chapter 5 and Chapter 6. Make a note of
which diskette to use, and continue with Step 2.
2
Select either Express or Advanced setup.
Note:
If you receive an “ Unsupported Hardware Con-
figuration ,” message during setup, contact the system
manufacturer. The ARO-1130U2 is not supported by
the system.
■
Express setup automatically updates the ARO-1130U2
BIOS. Select Express setup and the utility will do the rest.
When prompted, remove the floppy disk and press any key
to reboot the system.
■
Advanced setup also allows you to update the
ARO-1130U2 BIOS. In addition, Advanced setup allows
you to select other options such as:
– Display Current BIOS Checksum . Determines current
version of the ARO-1130U2 BIOS.
– Display New BIOS Checksum . Determines version of
the BIOS available on the floppy.