Page 43
The Cinema Reference has the ability to recall one of three volume
levels when it is turned on. The Out Of The Box Setup has the
Cinema Reference always turning onto VOL PRESET 1 which is
factory set for all channels and all inputs at -25.0 dB. This level is
typically a low or moderate volume level. If you have already com-
pleted the section on “Audio Setup”, then you may have already
locked in a new audio preset on VOL PRESET 1.
Factory Default Note: The Cinema Reference has been
preprogrammed in the factory such that both VOL PRESET 1 and
VOL PRESET 2 have the same preset level of all channels on all
inputs set to -25.0 dB. If you wish to instantly recall the factory
settings, simply proceed to recall VOL PRESET 2 by turning the
CHANNEL knob until the display reads VOL RECALL 2 and then
press the CHANNEL knob. If you wish to reset VOL PRESET 1 to
the factory default as to begin again, once you have recalled VOL
PRESET 2, simply turn the CHANNEL knob until the display reads
VOL RECALL 1 and then press and hold the CHANNEL knob until
the display reads VOL STORED 1.
If you want the Cinema Reference to come on to a volume level
other than VOL PRESET 1, you can alter it to come on to either VOL
PRESET 2 or LAST USED.
To alter the Cinema Reference’s Turn On Volume:
1
Turn the MODE knob clockwise until the display reads SETUP
MODE and then press the MODE knob.
2
Turn the MODE knob clockwise to until the display reads
TURNON VOL press the MODE knob. The top line of the
display will read the current turn on volume setting.
3
Turn the MODE knob until the display reads the desired turn
on volume. Then press the MODE knob to lock in that
turn on volume.
Custom Setup - Turn On Volume
The Cinema Reference’s “Out
Of The Box” Setup has the
Cinema Reference always
turning on to VOLUME
PRESET #1. Unless you have
already locked in a new
volume preset under Audio
Setup, this level will be -25.0
dB.
You can opt to alter the Turn
On Volume to either VOLUME
PRESET #2 or the LAST USED
volume level. The steps
described in the paragraph to
the right detail how to change
the Cinema Reference’s Turn
On Volume.
Note
ADA strongly recommends
using a Turn On Volume
Preset whose level is not too
high. Since the last volume
used might be ear shattering,
having the Cinema Reference
turn on to a preset volume
level removes the chance of
engaging a system that is
ready to sand-blast a room.
This is providing that the
Volume Preset you select is
also of moderate level.
