Page 51
The Cinema Rhapsody provides you with the ability to turn its front
panel infrared receiver on and off via software. If you are using the
Cinema Rhapsody in an environment which is flooded by other in-
frared signals (from high intensity light bulbs, high frequency lamps,
IR motion detectors, sunlight, etc.), you may opt to turn the Cinema
Rhapsody’s front panel infrared receiver off. You may also want to
turn this IR receiver off if you are controlling the Cinema Rhapsody
from a computer controlled touch screen or ADA keypad as, in some
instances, this IR receiver will prevent component control due to
data reflection.
The Cinema Rhapsody’s “Out Of The Box” setup has the IR receiver
in the On position. To turn the IR receiver off or on:
1
While in the Pro Setup Mode, turn the MODE knob clock-
wise until the display reads IRR CONTROL and then press
the MODE knob. The Cinema Rhapsody’s display will
read IRR CONTROL on the top line and the second line
will read “IS NOW ON” or “IS NOW OFF”.
2
Turn the MODE knob until the display reads the correct set-
ting for the IR Receiver, ON or OFF.
3
To exit the IRR Control Setup Mode without leaving the Pro
Setup Mode, press the MODE knob. If you wish to exit
the Setup Mode completely, turn any of the knobs other
than MODE or INPUT.
Pro Setup - IR Receiver On & Off Control
The Cinema Rhapsody
permits you to turn off the
front panel IR receiver via
software. This is useful if the
Cinema Rhapsody is being
touch screen controlled as
some installations will cause
the front panel IR to reflect
data transfers and prevent
control.
To change the Speaker System Configuration for individual inputs:
1
While in the PRO SETUP mode, turn the MODE knob until the display reads SPKR SYS IND
and then press the MODE knob. The display will read BASS CONFIG on the top line and
the second line will read the IND CONFIG #.
2
Turn the INPUT knob (In the BASS CONFIG Setup Mode, turning the INPUT knob does not
eject you from the Pro Setup) to select the input you wish to adjust. The top line of the
display will momentarily display the input you have selected (turned to) and the display will
then indicate this input’s BASS CONFIG/IND CONFIG #.
3
Turn the MODE knob until you have set the IND CONFIG # to the desired setting (from 0
{default & THX setting} to 12). You do not need to press the MODE knob to engage the
bass configuration and if you wish, you can listen to the different configurations as you dial
through them.
4
If you wish to alter the Speaker System Configuration for any or all other inputs, repeat steps 2
& 3. To exit the Bass Configuration Setup Mode without leaving the Pro Setup Mode, press
the MODE knob. To exit this setting, press the MODE knob (to return to the PRO SETUP
mode) or turn the VOLUME knob (to exit the SETUP mode entirely).
Please note, if you were to now enter the SPKR SYS ALL setting, you will reset every individual setting
completed in the steps above.