Page 44
The Cinema Rhapsody permits access to the “One Time” Setup func-
tions through its “Pro Setup”. The Pro Setup is well protected from
accidental access in order to best preserve the Cinema Rhapsody’s
“Out Of The Box” factory default parameters. Since the Cinema
Rhapsody is designed for optimum operation, these parameters may
not need to be adjusted, and as such, under most circumstances,
should be left alone.
The features that are available in Pro Setup are:
Delay Settings - Each channels delay (including Sub) can be set in
0.5 dB steps.
Network Bus - The setting of the ADA Bus™ address.
Final Input - Setting the maximum number of Input Labels that appear on
the Cinema Rhapsody.
Speaker System Setup Individual - Set speakers for specific inputs.
Speaker System Setup All - One step speaker setup for all inputs.
Bass Limiter - Bass Peak Limit Manager is set by listening to software.
Bass Limiter Set - Bass Peak Limit Manager is set using pink noise.
HDR Up Scale - Setting the High Dynamic Range scale factor for AC-3.
LDR Dn Scale - Setting the Low Dynamic Range scale factor for AC-3.
Re-Equalize - Turning the THX Re-Equalizer on and off for each input.
Timbre Match - Turning the THX Timbre Match on and off for each input.
Decorrelate - Turning the THX Adaptive Decorrelation on and off for each
input.
Auto-Balance - Turning the Auto-Balance on and off for each input.
Repeat Count - Setting the maximum number of consecutive blocks re-
peated before muting for Dolby Digital modes.
Analog Gain - Adjusting the gain control from 0 d B to +9 dB, in 3 dB steps
per input.
PCM Scale - Adjusts the PCM scale per AC-3 or non-AC-3 modes.
IRR On/Off - Turning the Cinema Rhapsody’s front panel IR receiver on
and off.
Input Format - Sets the Dolby Digital decoding input format per input.
Aux DC Trig 1 - Sets the Auxiliary Trigger #1 to engage with specific inputs.
Aux DC Trig 2 - Sets the Auxiliary Trigger #1 to engage with specific inputs.
Effect Delay - Sets the effect delay for Stereo & Mono Enhance modes.
Effect Level - Sets the level of effect for Stereo & Mono Enhance modes.
To enter the Pro Setup Mode:
1
Turn the MODE knob clockwise until the display reads SETUP
MODE and then press the MODE knob.
2
Turn the MODE knob clockwise to until the display reads
PRO SETUP and press and hold the MODE knob. The
top line of the display will read PRO SETUP and the sec-
ond line of the display will read T-MINUS 10, T-MINUS
9,.....T-MINUS 1. At this time the display will flash and the
top line will return to read PRO SETUP and the second
line will now read the first Pro Setup function, NETWORK
BUS.
3
To exit the Pro Setup Mode, turn any knob other than the
mode and input knobs. Turn the mode knob to access
the above mentioned parameters.
Pro Setup
The Cinema Rhapsody has
additional parameters that can
be set under the Pro Setup
Mode. These parameters are
set in the factory for optimum
performance.
To protect these factory
settings, the ability to access
the Pro Setup mode requires
the turning of the MODE knob
until SETUP MODE appears
followed by pressing and
holding of the MODE knob for
a countdown of ten seconds.
When in the Pro Setup Mode,
you can still access functions
typically limited to the
standard Setup Mode.
There is no time-out function
while in Pro Setup.
To exit the Pro Setup Mode,
simply turn the INPUT knob.