32
OPERATION GUIDE
A. This appliance has a pilot. It is equipped with an ignition
device which automatically lights the burner. Do
NOT
try to
light the burner by hand.
B. BEFORE OPERATING smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance
•
Do not touch any electric switch; do not use any phone
in your building.
• Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire
department.
C. Only use your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or turn by
hand, don’t try to repair it, call a qualified service technician.
Force or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control
system and any gas control which has been under water
1. Turn off all electric power to the appliance if service is to
be performed.
2. Remove control access panel
3. Push in control knob slightly and turn clockwise
4. Replace control access panel
1. STOP! Read the safety information above on this label.
2. Turn off all electric power to the appliance.
3. This appliance is equipped with an ignition system which
automatically lights the burner. Do NOT try to light the
burner by hand.
4. Push in gas control knob slightly and turn clockwise.
5. Wait five (5) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas, STOP!
Follow “B” in safety information above on this label. If you
don’t smell gas, go to the next step.
6. Turn gas control knob counterclockwise
to “ON”
7. Replace control access panel
8. Turn on all electric power to appliance
9. If the appliance will not operate, follow the instructions
“To Turn Off Gas to Appliance” and call your service
technician or gas supplier
FOR YOUR SAFETY, READ BEFORE OPERATING
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION
MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
GAS CONTROL
KNOB SHOWN
IN “ON” POSITION
GAS INLET
HONEYWELL
ON
OFF
Note: Knob cannot be turned to
“OFF” position unless knob is
pushed in slightly. Do not force.
Note: Knob cannot be turned to
“OFF” position unless knob is
pushed in slightly. Do not force.
BL_ST_INSTL_RevB_4.08.19
