Installation and Commissioning Guide
Variable Capacity Commercial
7
Installation and Commissioning Guide - Split Ducted Variable Capacity Commercial Outdoor Unit
Doc. No.0525-066 Ver. 6 221012
Charge refrigerant into the system only after the equipment does not leak or contain moisture. Ensure that R-410A is
only charged in liquid form. Take into consideration the correct amount of refrigerant charge specifi ed for the system
to ensure effi cient unit operations. When charging is complete, reclaim refrigerant from charging lines into an approved
refrigerant container. Seal all used refrigerant containers with approved closure devices to prevent unused refrigerant
from escaping to the atmosphere. Take extra care to maintain all service equipment directly supporting refrigerant
service work such as gauges, hoses, vacuum pumps and recycling equipment.
INSTALLATION PREPARATION (Pre-Installation considerations)
The following items must be considered before beginning the unit installation:
• Verify the unit capacities and ratings with the unit nameplate
• Make certain the fl oor or foundation is level, solid and have suffi cient structural strength to support the unit and
accessories weight.
• Allow minimum recommended clearances for periodic maintenance and service access.
• Allow suffi cient space above the unit for the outdoor air discharge. Condenser air inlet, located on the coil side of the
unit, requires suffi cient airfl ow clearance for the optimum unit performance.
• Note the conditioned supply air and return air location. Ensure suffi cient spaces are allocated for these purposes.
• Refer connection and location of condensate drain in the unit drawing and dimensions section of this manual.
• Wiring connections must be in accordance with the wiring diagram provided with the unit.
• Make sure all wirings are in accordance with local electricity authority regulations and standards.
• Do not install the unit close to an area where there is a danger of fi re due to volatile, explosive, fl ammable and/or
hazardous materials.
• Ensure that spaces around the unit are free from any obstructions for optimum unit performance.
• Installer to ensure correct size/type that main circuit breaker and cable is installed in unit sub-mains to protect the
sub-mains and unit wiring.
• Installer to ensure correctly rated residual current device (RCD) is installed as per with the latest edition of the
AS/NZS 3000 (also known as Australian Wiring Rules).
• Secure the power cords and control cables that goes in/out the unit. Use the cable ties provided in the control box.
CAUTION
• This outdoor unit is designed to match only with an ActronAir indoor unit as specifi ed in the Technical Selection
Catalogue.
• This unit is designed for use with R-410A refrigerant only.
• The unit is supplied with factory charged R-410A refrigerant. Be aware of all the relevant regulations concerning the
handling of refrigerant.
05. Wall Control Operation Manual Access
Download from website
LC7-2
Operation Instruction can be downloaded through our website shown below.
https://www.actronair.com.au/brochures-manuals/#operating-manuals
NEO
Operation Instructions can be accessed through our website shown below.
http://neo.actronair.com.au/user-guide/Components Overview
Содержание CRV290T
Страница 55: ...THIS PAGE WAS INTENTIONALLY LEFT BLANK...
