Actidata actiNAS cube RDX, Руководство пользователя

Страница: 17 / 168

17
Getting Started with the NAS System · Installation
Getting Started with the NAS System
NAS Hardware Setup
1. Attach network cable to LAN0 Ethernet port. Connect the other end of network cable to your network
hub or switch. You may also connect the other Ethernet ports if needed.
2. Plug in the power cord into the AC Power Input Socket located at the rear of the
subsystem.
3. To turn on the NAS, press the Power On/Off Switch.
4. The Power LED on the front panel will turn green.
Installing Hard Drives
This section describes the location of the hard drives in the NAS system and gives instructions on
installing a hard drive. The system supports hot-swapping allowing you to install or replace a hard drive
while the system is running.
a) Make sure the lock indicator is in unlocked position.To pull out a disk tray, press the Lock
Indicator Button. Pull the handle outwards to remove the disk tray from the enclosure.
b) Place the hard drive in the disk tray.