ACS-CONTROL-SYSTEM GmbH
l Lauterbachstr. 57 l D-84307 Eggenfelden l www.acs-controlsystem.de l [email protected]
20
5. Setting up the device
18
Menu level
Parameterisation level
Special function digital input,
dIG.In:
Default:
no
For the operation mode, special functions can be deposited on the digital input. This function is
actuated by pushing the key. With
tArA
the device is tared to zero and saved permanently as
offset. The device confirms the correct taring by showing
ooooo
in the display.
Set.tA
switches
into the offset value and can be changed via the navigation keys
[
▲
] [
▼
]
. Via
totAL
the current
value of the totaliser can be displayed for approx. 7 seconds, after this the device changes
back on the parameterised display value. If
tot.rE
is deposited, the totaliser can be set back by
pressing the navigation keys
[
▲
] [
▼
]
, the device acknowledges this with
ooooo
in the display.
The configuration of
EHt.rE
deletes the min/max-memory. If
HOLD
was selected, the moment can
be hold constant by triggering the digital input, and is updated by releasing the key.
Advice:
Hold
can only be activated, if
HOLD
was selected under parameter
DISPL
.
Under
ActuA
the
measurand is shown for approx. 7 seconds, after this the display returns to the parameterised
display value. The same applies for
AVG
, here the sliding average value will be displayed. A
sensor calibration is done by triggering of the digital input via
se.cal
, the flow diagram is shown
in
chapter 8
. The constant value
const
can be recalled via the digital input, or changed digit per
digit. At
AL-1…AL-4
there can be set an output and therewith e.g. a setpoint adjustment can be
done. If
no
is selected, the
[O]-
key is without any function in the operation mode.
Back to menu group level,
rEt
:
With
[P]
the selection is confirmed and the device changes into menu group level
„–fct–“
.
…
