43
E N
42
E N
bLOWer
Problem
diagnosis
Steps to take
restarting
The LED is
blinking.
The blower is
overheating.
• Switch the blower off at the
button, make sure the
ON LED is off.
• Make sure there is no towel
or other item blocking the air
circulation in the blower.
• Check the condition
of the filter and clean it if
necessary.
• Reposition the filter
correctly in its housing.
• Wait a few minutes then
press and hold the
button for 5 seconds to
reset the blower.
• Switch the blower back on
and make sure the LED
is off. The blower is now
ready to receive instructions
from the remote control to
restart (see chapter 3.1).
The blower
stops and does
not restart.
Timeout period.
Allow the blower to cool
down.
See chapter 3.1.2
The blower
does not start.
Loss of signal from
the remote control.
Move the remote control.
Test the reception.
The blower is
switched off.
Press the button on
the blower.
Electricity supply
problem.
Check the electrical
installation.
The FILTER
and LEDs
are blinking.
There is no filter or
it is positioned
incorrectly.
• Reposition the cleaned
filter correctly in its seat,
the FILTER LED will then
be turned off.
• Hold down the button
for 5 seconds to reset it and
check that the LED is off.
The blower is now ready
to receive instructions from
the remote control to start
(see chapter 3.1).
The FILTER
LED lights up.
After approximately
200 hours of use,
the FILTER LED
lights up to indicate
the filter requires
cleaning.
• Turn off the blower at the
button.
• Pull out the filter situated at
the rear of the blower (see
above) and wash it in warm
water or clean it with a
vacuum cleaner.
• Reposition the filter, making
sure the grille is facing up.
After cleaning, you will
have to reset the blower
by holding the button
down for 5 seconds.
▼
▼
▼
Press the blower key for 5 seconds; the FILTER and LEDs go out.
4.3 Troubleshooting
Despite all our efforts in manufacturing our products, you may encounter some
easy-to-solve operating failures. In this case, please consult the table below to find our
suggested solution.
Nonetheless, should you fail to solve the problem encountered, please contact
your supplier's after-sales service for assistance.
TOWeL rAdIATOr
Problem
diagnosis
Steps to take
restarting
The radiator
does not
heat.
The ON/OFF LED
is off.
• Press the button or
• Check the electricity supply.
See chapter 2.3
The heating LED
is on.
Check the electric heating element
of the appliance.
Contact your installer.
The heating LED
is blinking.
Check the temperature sensor.
Contact your installer.
The heating LED
is off.
Check the remote control signal:
• move the remote control
• or check the batteries
• or check if the remote control is
working.
See chapters 2.2 and 3.1.1
Press the
+
key to raise the
desired temperature.
See chapter 3.1.2