3A
Warning
y
To prevent or reduce the risk of electrical shock or fire, do not expose the unit to
rain or moisture.
y
Do not open the unit within five minutes after switching off.
y
The housing, the lenses, or the ultraviolet filter must be replaced if they are
visibly damaged.
Caution
There are no user serviceable parts inside the unit. Do not open the housing or
attempt any repairs yourself. In the unlikely event your unit may require service,
please contact your nearest dealer.
Installation
The unit should be mounted via its screw holes on the bracket. Always ensure
that the unit is firmly fixed to avoid vibration and slipping while operating. And
make sure that the structure to which you are attaching the unit is secure and is
able to support a weight of 10 times of the unit’s weight. Also always use a safety
cable that can hold 12 times of the weight of the unit when installing the fixture.
The equipment must be fixed by professionals. And it must be fixed at a place
where is out of the touch of people and has no one pass by or under it.
2. Technical Specification
◇
Extremely small, fast and powerful LED moving beam.
◇
DMX Channels: 8/12/15
◇
Pan/Tilt: 630
°
/200
°
, speed adjustable
◇
Smooth electronic dimming: 0-100%
◇
Electronic strobe with pulse and random effects
◇
Optional easy controller CA-8/CA-9 RTX for instant lighting shows at your
fingertips
◇
High efficiency, low power consumption
◇
Super compact, low weight
Voltage:
100V~240V, 50/60Hz
Fuse:
T 6.3A
20A
5. Troubleshooting
Following are a few common problems that may occur during operation.
Here are some suggestions for easy troubleshooting:
A. The unit does not work, no light and the fan does not work
1. Check the connection of power and main fuse.
2. Measure the mains voltage on the main connector.
3. Check the power on LED.
B. Not responding to DMX controller
1. DMX LED should be on. If not, check DMX connectors, cables to see if link
properly.
2. If the DMX LED is on and no response to the channel, check the address
settings and DMX polarity.
3. If you have intermittent DMX signal problems, check the pins on connectors or
on PCB of the unit or the previous one.
4. Try to use another DMX controller.
5. Check if the DMX cables run near or run alongside to high voltage cables that
may cause damage or interference to DMX interface circuit.
C. Some units don’t respond to the easy controller
1. You may have a break in the DMX cabling. Check the LED for the response of
the master/ slave mode signal.
2. Wrong DMX address in the unit. Set the proper address.
D. No response to the sound
1. Make sure the unit does not receive DMX signal.
2. Check microphone to see if it is good by tapping the microphone
E. One of the channels is not working well
1. The stepper motor might be damaged or the cable connected to the PCB is
broken.
2. The motor’s drive IC on the PCB might be out of condition
