13A
Reset All
Press the
MENU
button up to when the
Reset
is blinking on the display.
Pressing
ENTER
button and all channels of the unit will return to their standard
position.
3.3 Home Position Adjust
In the main functions, hold
Enter
button for at least 3 seconds into offset mode,
use
DOWN
and
UP
button up to chose
Pan Offset
or
Tilt Offset
, pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to adjust the home
position of the Pan, Tilt, Once the position has been selected, press the
ENTER
button to setup, to go back to the functions without any change press the
MENU
button again. Hold and press the
MENU
button about one second or wait for one
minute to exit the menu mode.
4. How to Control the Unit
You can operate the unit in three ways:
1. Master/slave built-in preprogram function
2. Easy controller
3. Universal DMX controller
No need to turn the unit off when you change the DMX address, as new DMX
address setting will be effect at once. Every time you turn the unit on, it will show
“CM-108” on the display and move all the motors to their ‘home’ position and you
may hear some noises for about 20 seconds. After that the unit will be ready to
receive DMX signal or run the built in programs.
4.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the
other units to give an automatic, sound activated, synchronized light show. This
10A
again. Hold and press the
MENU
button about one second or wait for one minute
to exit the menu mode.
Back Light
Select
Back Light
, press the
ENTER
button to confirm, present mode will
blink on the display. Use the
DOWN
and
UP
button to select the
On
(Led on) or
Off
(Led off) mode. Once the mode has been selected, press the
ENTER
button to
setup, to go back to the functions without any change press the
MENU
button
again. Hold and press the
MENU
button about one second or wait for one minute
to exit the menu mode.
Function Delay
Select
Function Delay,
press ENTER button to confirm, present mode will
blink on the display. Use
DOWN
and
UP
button to select the
No Delay
or
1S/2S/3S
Delay
(Wait for 1/2/3 seconds before these Functions of 12CH are
activated/deactivated)
mode. Once the mode has been selected, press the
ENTER
button to setup, to go back to the functions without any change press the
MENU
button again. Hold and press the
MENU
button about one second or wait for one
minute to exit the menu mode.
White Balance
Select
White Balance
, press
the
ENTER
button to confirm, present mode will
blink on the display. Use the
DOWN
and
UP
button to select the
Red
or
Green
or
Blue
. Once the mode has been selected, press the
ENTER
button to setup, use
the
DOWN
and
UP
button to change the value (125~255). Once the mode has
been selected, press the
ENTER
button to setup, go back to the functions without
any change press the
MENU
button again. Hold and press the
MENU
button about
one second or wait for one minute to exit the menu mode.
Dimmer Calibrated
Select
Dimmer calibrated
, press
the
ENTER
button to confirm, present mode
will blink on the display. Use the
DOWN
and
UP
button to change the value
(50~100). Once the mode has been selected, press the
ENTER
button to setup, go
back to the functions without any change press the
MENU
button again. Hold and
