![background image](http://html.mh-extra.com/html/acer/veriton-m6610/veriton-m6610_service-manual_2838221007.webp)
vii
System Tour
1
Features
1
Block Diagram
6
System Components
7
Front Panel
7
Rear Panel
8
Hardware Specifications and Configurations
9
Power Management Function(ACPI support function)
12
System Utilities
13
CMOS Setup Utility
13
Entering CMOS setup
14
Navigating Through the Setup Utility
14
Main
15
System Disassembly and Assembly
25
Disassembly Requirements
25
Pre-disassembly Procedure
26
Removing the Side Panel
27
Removing the Front Bezel
28
Removing the Heat Sink Fan Assembly
29
Removing the Processor
31
Removing the VGA Card
33
Removing the Memory Modules
34
Removing the Hard Disk Drive
35
Removing the Optical Drive
37
Removing the Printer Port Cable and COM Port Cable
39
Removing the Intrusion Alarm and OBR Cable Cable
41
Removing the System FAN
43
Removing Other Side Pannel
45
Removing the Power Supply
46
Removing the Card Reader
48
Removing the Internal Speaker
49
Removing the Mainboard
50
Removing the Front I/O and USB Assembly
52
Removing the Power Switch and LED Cable Assembly
54
Assembly Requirements
55
Assembly Procedure
56
Install the Processor
57
Install the Memory
58
Install the Heat Sink Fan Assembly
59
Romoving the both Side Panel
60
Install the I/O Shielding
61
Install the Main Board
62
Install the System Fan
64
Install the Optical Drive
66
Install the 3.5’’ Card
68
Install the COM Port Cable and Printer Port Cable
71
Install the Hard Disk Drive
73
Install the Right Side Panel
76
Install the VGA Card
77
Install the Front Bezel
79
Table of Contents
Содержание Veriton M6610
