73
Removing and installing memory
modules
The four DIMM sockets onboard support 1024-MB registered SDRAM
DIMMs for a maximum memory capacity of 4 GB.
Note:
The registered SDRAM module should work under 3.3 volts;
5-volt memory devices are not supported.
For data integrity, the default setting of the ECC (error correcting code)
function of the memory system in BIOS is enabled. Refer to “IPMI
Configuration” on page 107 for more information on this BIOS
parameter.
Note:
The system board supports both 100 and 133 MHz
registered SDRAMs; 66 MHz SDRAMs are not supported.
Removing a DIMM
Before you can install a new DIMM in a socket, remove first any
previously installed DIMM from that socket.
1
Remove the housing panels. Refer to page 51 for more detailed
instructions.
2
Locate the DIMM socket on the mainboard.
3
Press the holding clips on both sides of the socket outward to
release the DIMM (
a
).
4
Gently pull the DIMM upward to remove it from the socket (
b
).
AA G610.book Page 73 Monday, October 22, 2001 9:46 AM
Содержание Altos G610
