Manual Part # 800-1070-001, Rev G, 10-2008
Page 10 of 16
illuminated bar indicates an additional 1/64 of an inch of measurement.) For
better resolution, switch to 1/32 or 1/64 mode. For the best resolution and
accuracy switch to a decimal mode – inches or millimeters..
When the measurement is greater than 99 63/64 inches, a
+100
+100
+100
+100
and/or
+200
+200
+200
+200
will illuminate in the upper right portion of the display to indicate this amount
must be added to the displayed reading. ie: If the measurement is 154 5/8
inches, 54 5/8 and
+100
+100
+100
+100
will be illuminated on the display. If the measurement
is -307 23/64 inches, - 7 23/64,
+100
+100
+100
+100
and
+200
+200
+200
+200
will be illuminated on the
display.
+,
DATUM
, and -
The
+
(plus),
DATUM
and
–
(minus) keys are used to change the currently
displayed position to a different value. The
DATUM
key forces the readout to
display a user programmed value.
Programming Parameter Pr1
Momentarily depressing the
+
key increments the current position by one unit
of measurement. Momentarily depressing the
–
key decrements the current
position by one unit. Pressing and holding the
+
or
–
keys will cause the
displayed position to change continuously. Holding down the key will cause the
amount of change to speed up. This allows for quick adjustments over a range
of large values.
NOTE: While the
DATUM
key can be used to simply “zero” the currently
displayed value, it can also be programmed to force the readout to a preset
value. This can be zero, or any other displayable value.
See Section 3: Readout Programming,
Programming Parameter Pr1.
Reverse Readings
Reverse readings means changing the direction of readings produced by
moving the stop. If the DigiStop decrements (reduces or goes negative) when
it should be incrementing (increasing or going positive), the readout will need
to be re-programmed for your installation (right vs left infeeds).
See Section 3: Readout Programming,
Programming Parameter Pr2.
