Accorroni HR 3.0, Руководство по установке

Страница: 27 / 53

27
Press and release in programming:
allows you to scroll through folders
parameters (ST, CF, etc); allows it
scrolling the list of parameters.
Parameter being edited
increases its value.
___________________________________________________
Press and release:
from main view allows
the display of the probe values
configured (temperatures / pressures)
in the upper display and the label
corresponding in the lower display.
___________________________________________________
Pressure and release
in programming:
allows you to scroll through folders
parameters (ST, CF, etc); allows it
scrolling the list of parameters.
In phase of modification of the parameter
decreases its value.
___________________________________________________
Press and release:
allows you to turn on the machine
(in chiller or heat pump)
or select the std-by mode
___________________________________________________
Press and release:
allows you to turn on the machine
(in chiller or heat pump)
or select the std-by mode.
___________________________________________________
Press and release:
allows you to access the functions menu.
Press 3 seconds and release:
allows you to adjust the clock
in the models in which it is provided.
Press and release in programming:
allows you to exit
from the parameter modification.
___________________________________________________
Pressione contemporanea dei tasti
per 3 secondi:
Simultaneous pressing of the keys
for 3 seconds:
___________________________________________________
Pressione contemporanea dei tasti:
1. consente l’uscita dalla
programmazione parametri.
2. la pressione contemporanea
prolungata dei tasti consente
l’ingresso in sbrinamento manuale.
___________________________________________________
Remote terminal
As regards the use of the remote terminal (indications on the
display and meaning of the keys) refer to the previous paragraphs.
In the air / air units, if the remote terminal equipped with an NTC
probe (VICXS610) is used, by configuring
par. CF35 = 2 the display will show the ambient air temperature;
this probe will be used by the controller for thermoregulation. In
the event of a fault in the remote controller / terminal or an error
in the wiring, the lack of communication between the instrument
and the remote terminal will be signaled on the display with the
error message “noL” (no link).
8.4 ACCESS TO PARAMETERS
1 Press the SET and down arrow keys for a few seconds;
2 The icons flash and the upper display displays
“ALL” (generic group of parameters)
3 Scroll through the parameter groups
with the keys and select the group
containing the parameters to be modified; pressing the button
set allows you to access the list of parameters contained
in the group. The lower display shows the parameter label
and the upper display shows the value.
8.5 VIEW AND MODIFY THE SET POINT
Pressing and releasing the SET key allows the set point to be
displayed.
Pressing the SET key for a long time allows its modification:
1 Press the SET button for at least 3 seconds;
2 The set point will be displayed flashing;
3 To modify the value, use the keys and
4 Save the new set point by pressing the SET or button
wait for the time out time to exit the program.
User interface