Acclaim Lighting aria Dyna Accent, Руководство пользователя

Страница: 25 / 42

23
www.acclaimlighting.com
CHANGING THE DISPLAY SETTINGS
This option contains four settings related directly to the user display:
•
Display Invert
- allows you to invert the text on the user display so that it reads correctly
when the fixture is mounted upside-down.
• Display Warning
- when set to On, a warning will appear on the display if the internal
temperature becomes too high, either due to the external environment or an internal
issue. The message reads:
Temperature warning - please check fixture
.
Note: In addition to showing a warning, the fixture will protect its emitters by automatically
reducing output to 50% if the maximum allowable operating temperature is exceeded. If the
over-temperature condition persists for more than 10 minutes, the fixture will close itself down.
• Temperature Unit
- allows you to change between
o
F and
o
C when displaying readings
in the
Fixture Information > LED Temperature
section.
•
Backlight Timeout
- determines whether the user display should automatically blank out
when it is not being used, or should remain on permanently to allow the DMX address to
be seen at all times. When set to Off, the time-out feature will be disabled and the display
will not blank out.
TO CHANGE DISPLAY SETTINGS
1 Enter the user menu (see page 19).
2 Use the or buttons to locate the
Display Setting
option and press ENTER .
3 Use the or buttons to locate the required sub-option and press ENTER .
4 Use the or buttons to change the sub-option setting and press ENTER .
SETTING AN INTERNAL COLOR/OUTPUT
This option allows you to mix a static color (or choose a white dimming level on single color
models) which will be displayed whenever the following two criteria are met:
•
The
Solo Behavior
option is set to
Internal Color Mode
(or
Internal Output Mode
) and,
•
There is no DMX input signal.
Once configured, you need to activate the
Solo Behavior > Internal Color/Output Mode
.
See page 27.
TO SET AN INTERNAL COLOR/OUTPUT
1 Enter the user menu (see page 19).
2 Use the or buttons to locate the
Internal Color Mode
(or
Internal Output Mode
-
on single color models) option and press ENTER .
3 On color models, use the or buttons to locate the required color sub-option.
4 Press
ENTER .
5 Use the or buttons to change the dimming setting and press ENTER .
6 Repeat steps 3 to 5 on color models until the required overall color output is achieved.